2008 crv starter

2008 crv starter

The starter on your car is an electric motor with a gear that engages the flywheel or flexplate to turn your engine over and build compression to start the vehicle. Starters include a geared shaft, often called a Bendix, which extends during startup to engage the starter gear with the 2008 crv starter or flywheel, and retracts once the engine has started.

Log in. Sign up. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. Status Not open for further replies. Located directly under the intake manifold, its not readily accessible.

2008 crv starter

.

I rarely touch my regular hand ratchets now.

.

The starter on your car is an electric motor with a gear that engages the flywheel or flexplate to turn your engine over and build compression to start the vehicle. Starters include a geared shaft, often called a Bendix, which extends during startup to engage the starter gear with the flexplate or flywheel, and retracts once the engine has started. Many starter motors also have a built-in solenoid that sends voltage to the starter when the key is turned, but some older vehicles may instead have a remote-mounted starter solenoid that can be replaced separately. The starter or starter solenoid on your vehicle may wear out over time due to heat, oil contamination from a leak, or just regular damage experienced over a lifetime of use. If you hear clicking but your engine won't turn over, it could point to a weak starter motor, or your battery may be dead.

2008 crv starter

Is your Honda CR-V having trouble starting up? The issue might lie with a faulty starter. The starter is responsible for turning the engine over when you turn the ignition key. Over time, starters can wear out or become damaged, leading to starting problems. But fear not! Having everything prepared will save you time and frustration along the way.

Utah vs la clippers

Status Not open for further replies. The one on top of the starter cannot be removed because of the plastic shoulder around it. In retrospect, I think I should've chosen the 'below' approach, but didn't because I didn't have a lift or access to a floor jack. O'Reilly Auto Parts offers free starter testing on or off the vehicle, and performing this test can help you narrow down the issue to determine if your starter is the source of the problem. Next, in theory, you may be able to remove the black plastic plenum attached to the manifold. I'm not a contortionist. A giant slab of text is difficult to read. For the best experience please upgrade or visit the site on another browser. In either case, the starter may need to be replaced to restore your starting performance. If you can remove that 3rd bolt, that's the way to go. The radiator cross support does not need to be loosened at the bottom, just tilt it forward, The throttle body does not need to be removed. Reinstall the manifold, lightly tightening the bolts, beginning at the center then working outward. The drawback on the 'below' approach is that you can't see the rearward bolt on the starter; you must rely on feel. My breaker bar doesn't ratchet, so I couldn't get a purchase on either bolt. IggysCRV Replies.

.

Underneath the car, remove the plastic panel with the square access hole in it. This may seem like a lot of extra work but I'm retired and it works for me. But I had a real hard time in getting one bolt on there. Begin by disconnecting the battery cables. My breaker bar doesn't ratchet, so I couldn't get a purchase on either bolt. I find this gives me just enough room to access the knock sensor connector, starter connections and the other starter bolt. You have insufficient privileges to reply here. Starter Remanufactured. For a better experience, please enable JavaScript in your browser before proceeding. I used a screwdriver to rotate it to the unlocked position and disconnect the cable. The vacuum hose runs into the large air intake tube. The bolts are arranged in a triangle. I simply broke the shoulder to get to the nut. If you need a car battery, starter motor, solenoid, alternator, or other starting and charging system parts, O'Reilly Auto Parts carries the right parts to help you make a lasting repair and keep you on the road. The starter on your car is an electric motor with a gear that engages the flywheel or flexplate to turn your engine over and build compression to start the vehicle.

0 thoughts on “2008 crv starter

Leave a Reply

Your email address will not be published. Required fields are marked *