Psp go screws

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides. Open the back cover by gently lifting the right side, and rotating it to the left side as if psp go screws were opening a book.

Does not include the display. Clear all filters. Item Type. Batteries 1. Buttons 9. Cables 1. Case Components 9.

Psp go screws

.

Screens 3. Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

.

Does not include the display. Clear all filters. Item Type. Batteries 1. Buttons 9. Cables 1. Case Components 9. Display Components 2.

Psp go screws

Try adjusting your search or filter to find what you're looking for. Upgrade what's not. It's fast, easy, and safe to replace your screen , battery , joystick , buttons , case and more. Item Type: Screws and Bolts. Item Type. Antennas 2. Batteries 8. Boards 1. Buttons

Newgrounds worms

Slide the plastic opening tool around the perimeter of the display, increasing the gap between the metal frame and the front panel. Unplug the volume button cable using a pair of tweezers. Slide the plastic opening tool across the length of the display. This should loosen the glue binding the display to the plastic front panel. Buttons 9. Step 2. Cancel: I did not complete this guide. Almost done! Step 7. However, it is still connected to the frame, so don't remove it completely. What you need. During reassembly, make sure to properly line up the power button with the power button lever on the logic board. Fix Your Stuff Community Store. Step 1 Back Cover. Fix Your Stuff Community Store.

Complete repair manual for the PSP Go, including battery upgrade and display repair instructions. PSP Go.

Jerri Kohl - Apr 2, Reply. Batteries 1. Be very careful when disconnecting the following cables. Step 2. When putting a new battery into the PSP Go, make sure you hold the "Warranty Sticker" so you don't put the battery on top of it. Badges: Use a plastic opening tool to pop out the battery, being careful not to snag the "Warranty Void" sticker in the process. Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides. Badges: Wedge a plastic opening tool in between the connector and logic board, and gently pull the connector upwards. To reassemble your device, follow these instructions in reverse order. Be very careful when performing this procedure! This should loosen the glue binding the display to the plastic front panel.